Name: Fiber Optic Switch
Brand: AtGrating Technologies.

Fiber Optic Switch

The fiber optic switch AGS14 is a non-mechanical designed fiber optic device based on the Faraday effect with Bi-refringent crystal and micro-optical components. Without moving parts in the design, the switch can meet the high requirement on reliability, durability and high switching speed.

Features of Fiber Optic Switcher

High Speed
Non-Mechanical
High Stability & Reliability

Application of Fiber Optic Switcher

Fiber Optical Sensing
Switching
Latching
Signal Monitoring

Specification of Fiber Optic Switcher

1x4	Min	Typical	Max	Unit
Operation Wavelength	1500	1550	1600	nm
Insertion Loss	1.5	1.1	1.5	dB
PDL		0.1	0.2	dB
ER(PM version)	18			dB
Cross Talk	32	50	32	dB
PMD		0.1	0.2	ps
Return Loss	50			dB
Durability	1011			cycle
Operating Temperature	-5		70	℃
Optical Power			500	mW
Storage Temperature	-40		85	℃
Switch Type	Latching
Fiber Type	SMF28 / PM1550
Switch Time		0.8		ms
Power Input	DC 12V
Dimension	152mm142mm50mm

Serial (RS-232) Interface

Electrical characteristics: Conforms to the EIA-574 standard (EIA-232 (RS-232), 9-pin) Baud rate: 2400, 9600, 57600, 115200, 230400

Start bit: 1 bit, fixed Data length: 8 bit, fixed

Parity: Odd, Even, or None Stop bit: 1 bit(default)

Connector: DELC-J9PAF-13L6 (JAE or equivalent) Flow control: None

UART bit formats are listed in the following table:

Parity	UART frame
None	\| Start bit \| 8-bit data \| Stop bit \|
Odd/Even	\| Start bit \| 8-bit data \| Parity bit \| Stop bit \|

Ethernet Interface

Electromechanical specifications: Conforms to IEEE802.3 Transmission method: 10BaseT/100BaseTX Ethernet Communication protocol: TCP/IP

Connector type: RJ45

Port number used: 8080 (fixed)

Configure Network Information

Visit the website http://192.168.1.100/, 192.168.1.100 is a device IP address. The default network information is on the nameplate attached to the device.

Fiber Optic Switcher

Note: Visit configuration website will increase the switch time when the AGS14 is working at switch mode.

The Ethernet port just supports static IP mode, please avoid conflict with other network devices in the same subnet. If the device has been set to the wrong IP and can`t be accessed any more，push the Restore Button for 6 seconds to restore the default settings. When push down the Restore Button, the LED will twinkle until restore succeed.

Data frame formats about TCP/UART

A complete frame contains 2 bytes: fixed start byte and command byte. Start byte Command byte

0xF0(Fixed) 1-byte data

Once the client transmits the command, it needs to wait for the device to reply.

Function	Transmit frame (hexadecimal)	Reply frame (hexadecimal)
Say hello, use for test connection, the device will do nothing	0xF000	0xF000
Switch to channel 1	0xF001	0xF001
Switch to channel 2	0xF002	0xF002
Switch to channel 3	0xF003	0xF003
Switch to channel 4	0xF004	0xF004